i bought for my private study a launchxl-f28379D and launchxl-f280049C , i've never had an experience with that mcu's before . I'm using a CCS version 12.6.0.00008 on Win11 . I had a problem with ...

I am using the following configuration and setup. All readings start to drift significantly around 80 C to 125 C. Any idea why is that?

I need help about data rate time for Turbo Mode, Data Rate (011: 350 SPS), Continuous Mode. I will share the code below. (ADS1220_default_regs:0x01, 0x74, 0xC0, 0x00) I connected potentiometer to the ...

one of my top optical module customer is evaluating AMC60704 and met issue The SPI value written by AMC60704 DAC/ADC GUI software after the voltage is given according to the specification is ...

I will contact you offline to assist.

Vin: I created a circuit that boots from 5V to 6.3V and converts it to 5V with a regulator, but when I connect a 100mA load, Vout drops to 5.3V. Can you catch a waveform of the unexpected Vout drop.

i am inquiring on the long term stability data (ppm/√kh) for this DAC, for 1000 and 2000 hours, i did not find ant reference to stability on the website. We did not characterize this spec for this ...

We are using ADS124S108 for measurement of PTC1000 based temperature sensor in 3 wire configuration. Attached schematic for your reference. For board bring up i did following tests : 1. First testing ...

If we are using the part as a 1:4 buffer and not using the muxing capability should I ground both sides of RX1 plus OSCin? Also the part datasheet does not mention operation with spread spectrum. My ...

I am looking for the silent installation parameters for the setup ADS8681_EVM.exe. It should install ADS8681, National Instruments software and the Windows driver package - Tesys Instruments silent. I ...